eTraining Introduction How to Use This Module Introduction Choosing the Preparation Method Mount Fabrication Procedure Steel Etching Procedure Steel Polishing Procedure Rocks and Minerals Equipment Procedure Introduction Jet Spraying Lofting Suspension Odd Shapes - Fractures Cryo Fracture Technique Electronic Materials and Carbon Nanotubes Multiprep Polishing Procedure Handling Specimen Coating Reasons for Coating Metal Coating Procedure Carbon Coating Procedure Introduction Specimen Holders by Instrument Overview Interactive Parts Tour Operating Procedures Overview Chemicals and Materials Solution Preparation Chemical Calculations Fixation and Dehydration Mounting Safety and Disposal References Form and Function Signal Source and Detection Interactive Parts Tour Interactive Cutaway Tour Safety Procedures Operating Procedures Basic Imaging Advanced Imaging Shut Down FAQs Troubleshooting VIDEO: Specimen Loading Technique VIDEO: Start Up Technique VIDEO: Specimen Unloading Technique Form and Function 1 Form and Function 2 Chemical Analysis Interactive Parts Tour Interactive Cutaway Tour Software Tour Safety Procedures Preliminary Specimen Exchange Flashing Imaging Shut Down Backscatter Imaging Charging Specimen Types X-Ray Spectral Analysis X-Ray Mapping Why Use FESEM? Specimen Constraints General FAQs Troubleshooting Overview Tapping Mode Laser Alignment Preliminary Alignment Operation Image Viewing/Offline Operation Shut Down System Requirements Alternative Content Contact General Lab Safety Disclaimers Usage Permissions Site Map